Screen Printing Washout Booth DIY
Silkscreen washing booths are needed to clean frames from an emulsion. The cabins we produce are made of metal on a rigid metal structure. To protect the metal from corrosion, the entire cabin is painted with powder paint and dried in an oven. This technology of metal preservation allows protecting the metal against corrosion and aggressive chemical elements for a long time. The cabin is fully sealed and has a drain into the sewer.
How to make a screen printing washout booth?
The washer is the simplest device needed to prepare stencils. It is essentially just a wash basin with a splash guard. To create quality stencils, you definitely need a back light so that the printer can see how the small parts have been washed. And you need side curtains so there’s less splatter flying around.
Build a Screen Room
Homemade Washout Booth
Washout booth with WOODEN cabinet
Washout booth and Filter System
DIY Water Washout Booth Filtration for Screen Printing
The BEST Screen Printing Washout Booth
Stainless Steel Screen Printing Wash Tank Washout Booth with Backlight, Floor Type Screen Printing Washing Plate Tank (220V)
- Floor Type Stainless Steel Screen Printing Wash Tank Washout Booth with Backlight – This wash tank is equipped with 1 wash gun.
- The tank is made of all stainless steel, with a stainless steel leaking bucket and a downpipe. The width of the tank is 25.6″/65cm.16″ /41 cm long from front to back; Holding water at a height of 11.8″/30 cm; It can be used for washing various screen frames with the outside diameter within 25.6″/65 cm .
- The tank funnel is equipped with filtering bowl, sealing cover and downpipe; The water tank is equipped with a baffle frame rack, screen frames can be placed in each card slot of the baffle frame rack according to the size of the screen frame .to flush the screen plate at the most appropriate angle; The lower part of the baffle frame rack has a water guide to ensure that there is no water in the tank.
- The cloth can be pasted directly between the two lamp holders, to prevent the splash to the back.
- Screen plate inspection lamp adopts 23.6″ x 23.6″(60 x 60 cm) LED panel lamp with 28W power; The power supply can be installed on both sides as required, and the power switch is installed on the power cord; Check the additional screen plate baffle under the lamp, the screen plate can be placed on the baffle board for inspection.